Limestone Quarrying

Limestone Quarrying

Limestone Quarrying

Which brand of Limestone Quarrying Machine is good?

The Limestone Quarrying Machine is a commonly used milling equipment with the advantages of simple operation and high operating efficiency. In the actual production process, it is necessary to pay attention to the precautions of the Limestone Quarrying Machine in the manual, and only in this way can the efficient operation of the Limestone Quarrying Machine be guaranteed. Specific considerations are as follows.

Before the Limestone Quarrying Machine works, the staff should carry out a comprehensive inspection of the various components, including the tightening condition of the bolts, and timely loosen or tighten them to avoid affecting their normal operation. In addition, the degree of wear of each component must be adhered to, and the worn parts should be repaired or replaced in time. On the undercarriage plane of the re-distribution device, it is necessary to remove debris, dust, etc., so as to avoid the opportunity of mobile crushing to affect the work when the items cannot be ground.

Before the work, the staff must start the Limestone Quarrying Machine first, and then wait until it is running normally, then feed the Limestone Quarrying Machine. When the machine is shut down, wait until all the materials are unloaded, then stop the machine, and the staff should standardize the operation procedures. To ensure that it works properly. During the work process, the staff should also check the discharge port regularly. If the blockage is found, it should be removed in time to avoid affecting the output of the material. At the same time, we must also pay attention to the temperature of the bearing, the temperature rise should not exceed 25-30 °C of the surrounding air, so as to avoid the temperature is too high, causing damage to the Limestone Quarrying Machine. Also, the staff cannot move the movable bearings freely on the undercarriage to avoid accidents.

leave a comment